Today we are going to teach you how to convert a gasoline engine to run on water, that is, an engine with water as fuel. The hydrogen engine that runs on water is a chimera that has been said to be impossible for decades, but we have access to confidential and secret information, and we have discovered the compound HH+, which, if used as an electrolyte, can produce a large amount of hydrogen . This will be enough to run any motor
Index
00:00 Introduction
00:18 Preparing the pieces to cut them
00:30 Cutting the 304L stainless steel parts
00:53 Drilling the pieces (One 6mm and one 11mm hole in each piece)
01:18 Preparation of the Hydrolysis tank
01:45 Cutting the M6 threaded rods
02:00 Assembly of the Hydrolysis reactor
04:28 Preparation of the Hydrogen safety container
05:38 Manufacture of the support for the Hydrolysis equipment
06:15 Electrical connections
06:54 We remove the fuel tank and set up our Hydrolysis equipment
07:49 Preparation of the air filter
08:03 Filling the HH+ secret water and electrolyte reservoirs
08:41 Test inside the workshop
09:31 Carburetor adjustment
Hydrogen engine, ok. But if it is so efficient, why to continue to use oil engine? Easy and cheep to find water. Just go to the kitchen, take water and put in the engine and go. Non more expensive oil ! Non more time to waste to the pump for fuel oil.
it seems like magic but it works I converted my car and it works great. With a car you only have to manipulate the lamba probe with a 1.5V battery and let the hydrogen run through the air inlet after the air sensor in the carburetor, the consumption th…
Power produced will not be as much as power consumption to make HHO. But, I suppose with additional batteries and solar charging, I could certainly decrease petro used.
Are you going to hurt people at home if they try this at home. Just asking because as sweet as it looks, I have my concerns. Awesome if it works, great for camping